Caliper Piston Compressing tool

[longsock]

Re: Caliper Piston Compressing tool

I'm also looking to borrow Caliper Piston Compressing tool if anyone willing to lend me it? I'll be doing mine this Sunday

[stefan]

Re: Caliper Piston Compressing tool

pm'd about tools.

[J-hop]

Re: Caliper Piston Compressing tool

whoa, not sure you should be draining the lines first before adding new fluid, that will introduce huge airpockets into the system which will make it harder to properly bleed the lines. I've never heard of draining the lines before, but I could be way out to lunch.


Few tips from when i've done other cars:

- car off!
- don't ever push the brake pedal to the floor (on some cars will ruin the MC seals
- use a pressure bleeder if possible (way more effective then the pump-open screw-close screw-release method)
- bleed until you get fresh fluid coming out (pretty easy to tell if your fluid is old)
- all systems are different, the old rule of start at the farthest away screw and work your way up does NOT work on most of the cars i've done, so read your manual first (may work on vws but i've never bled the system on mine before)
- if you are going to do it the manual way you need two people, one person sits inside the car, applies pressure to the pedal, other person opens bleeder screw as the person inside presses the pedal down, person outside must be told to close the bleeder screw before the person inside releases the pedal or else you risk bringing air in

- you should have some sort of tubing connected to the bleeder screw to reduce the chance of an airpocket getting back into the caliper

- NEVER let the MC empty itself of fluid or you will have to start from scratch


added note for changing rear pads:
- use a clean turkey baster to remove some of the fluid before you try to push the calipers in or you will overflow the MC
- don't remove the rear carrier if you are doing the rotors at the same time, some DIYs say to do this but that is silly because you can easily slide the rotor out with the carrier in place

[GTI CANADIAN]

I gotta change the rear pads on my MKV GTI this weekend. Anyone got a piston compressing tool I could borrow? Where do I get anti-squeal paste?

Also, I heard one should change their brake fluid at least every 2 years. Is that pretty easy to do? I bled the brake lines on my buddies old 1969 Triumph GT6. Same thing right? Drain the fluid from each bleed valve; Fill her up with new fluid; and bleed.

So, on my GTI, correct me if I'm wrong; I have to pump the brakes with the engine running, have keep the brake down, and bleed air from the lines, starting with the caliper thats' furthest from the master cylinder first?


I bought stock pads, is there any kind of procedure to "Bed-in" the new pads?