Anybody know a machine shop that can bore a VR6 block?

[drewhastheinternet]

Hey everybody,
I bought a set of forged low compression pistons and rods that will make a 2.8 Vr6 into a 3.0. I know that there is a special stress plate needed to machine a vr6 block and many shops can't do it, so I was wondering if anybody in the edmonton/calgary area has had machine work done to a VR before?

[Disturbo]

Re: Anybody know a machine shop that can bore a VR6 block?

Precise can do it. Its the angle of the bore that makes it hard

[PRY4SNO]

Re: Anybody know a machine shop that can bore a VR6 block?

Haven't had a vr6 done before but The Block Shop Engines here in Edmonton on 118th is top notch. Robert was always on point to deal with, in my experience.

[Lars]

Re: Anybody know a machine shop that can bore a VR6 block?

Extreme Engine Development Ltd

B-3102 80 Ave SE, Calgary, AB T2C 1J3 Get directions
403-236-2949

http://dasdubbers.org/viewtopic.php?f=11&t=1777&start=0

One of the guys build thread that works there ... Vr6 turbo corrado..

[ToXicXxX]

Re: Anybody know a machine shop that can bore a VR6 block?

Not sure exactly who got used, but whomever Calgary Autoworks had bore out my old 1.8 AEB did a great job!

[MrSector9]

Re: Anybody know a machine shop that can bore a VR6 block?

yeah go see Kirk at extreme

[drewhastheinternet]

Re: Anybody know a machine shop that can bore a VR6 block?

Excellent! Thanks guys i'll give him a call tomorrow

[stuvy]

Re: Anybody know a machine shop that can bore a VR6 block?

I had to ship mine to Vancouver as nobody in Alberta that I could find was able to do a vr6. That was a few years ago now though.

[Natty54]

Re: Anybody know a machine shop that can bore a VR6 block?

Precise

Sent from my Nexus 5