If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
forgot to update this after i changed the trunk. i bought 2 444's off of tj so i am now running 3 compressors for the 2 tanks. they fill nice and quick. also trying out the badgeless grille for a little while, maybe ill make it permanent in the future. i also can stay away from the roof rack.
Anyways, we took the head off the one with the crappy motor and put it on the one with the good motor. So i have one good compressor. The exhaust plate was broken on one of Em.
Internal short in the motor from running too hot, probably caused by a stuck check valve, pressure builds up, head gets hot, motor gets hot, seizes, draws a fuk load of amps
So do you guys think there is anyway to rebuild these Compressors? Or would it not be worth my time or money?
You can rebuild them, if the motor is gone though, probably better to buy a new compressor. The 400c dual packs aren't too expensive. If you want to buy locally, I think KMS tools carries viair stuff.
Check valve for sure. Viair check valves fail all the time. Also, why would they be pulling 150a of current? Those compressors run at like 35 amps each.
Internal short in the motor from running too hot, probably caused by a stuck check valve, pressure builds up, head gets hot, motor gets hot, seizes, draws a fuk load of amps
one viar and one cheap one. contacts burnt from trying to pull ~150a of current through them.
the motor in one compressor had an internal short when it was hot and the other compressor wasn't making any pressure.
Check valve for sure. Viair check valves fail all the time. Also, why would they be pulling 150a of current? Those compressors run at like 35 amps each.
Leave a comment: