Announcement

Collapse
No announcement yet.

Flasher Relay Issue

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • stefan
    replied
    Re: Flasher Relay Issue

    i sprayed a whack of electrical cleaner in there, and it hasn't clicked since. been a little over a week now. see what happens.

    Leave a comment:


  • Stonewall
    replied
    Re: Flasher Relay Issue

    Originally posted by Kordain View Post
    Stop!

    be carefull with a propane heater in a confined space, they burn oxygen to make the flame and can quickly consume the air in a given space.

    Thank you for reading todays gratis safety anouncement.

    Carry on!
    Thanks for the hints but I have dealt with propane heaters for years. PLus the garage is not insulated or drywalled the the roof has plenty of venting.

    Leave a comment:


  • stefan
    replied
    Re: Flasher Relay Issue

    save 115$? its not that much trouble..

    Leave a comment:


  • 100%VAGitarian
    replied
    Re: Flasher Relay Issue

    if you go to the trouble of pulling the switch to clean it, why not just replace it and save doing it twice?

    Leave a comment:


  • Kordain
    replied
    Re: Flasher Relay Issue

    Stop!

    be carefull with a propane heater in a confined space, they burn oxygen to make the flame and can quickly consume the air in a given space.

    Thank you for reading todays gratis safety anouncement.

    Carry on!

    Leave a comment:


  • stefan
    replied
    Re: Flasher Relay Issue

    could certainly try that first

    Leave a comment:


  • Red90
    replied
    Re: Flasher Relay Issue

    OK, stop!!!!

    The problem is that little metal bits contaminate the grease in the turn signal switch.

    Get a can of contact cleaner. Stick the nozzle in behind the turn signal stalk. Spray, wiggle, spray........ That usually fixes the problem.

    If that is not succesful, you can remove, clean, regrease and reinstall the switch. You should not need to replace it.

    Leave a comment:


  • Stonewall
    replied
    Re: Flasher Relay Issue

    Garage is not heated but I just bought a propane heater... then emptied my tank lol I am going to fill it tomorrow and you know you are welcome to use it whenever you want I can even give you a hand as I have taken the airbag off and changed stalks etc on Ryans old car.

    Leave a comment:


  • 100%VAGitarian
    replied
    Re: Flasher Relay Issue

    disconnect battery. remove airbag. remove steering wheel, remove column covers. unplug switches. split the 2 switches apart. install new, repeat in reverse order.

    Leave a comment:


  • stefan
    replied
    Re: Flasher Relay Issue

    Originally posted by bocefus View Post
    I had this happen to me this past summer, just wait until it starts clicking non-stop all the time...

    I first replaced the hazard switch, it was cheap so might as well start there. Unfortunately it turned out to be the signal stalk and I had that replaced.

    I still have the hazard switch I bought, since the original was ok I didn't bother swapping it out, you can have it to test out if you want (it takes 30 seconds to swap out). I'm working out of town this week but I'll drop it at my office in the SE this morning just in case, pm you with the details.


    Shane
    Thanks, seems like there are enough cases here that i might as well just get the whole signal stalk right away.

    Big deal to swap this out? i can't imagine there is anything to difficult, other than being in an awkward spot.

    **found a few great DIY's, think its all within my capability... but if you've done it, feel free to chime in with advise.

    Brent... your garage isn't heated is it?
    Last edited by stefan; 11-22-2007, 10:50 AM.

    Leave a comment:


  • Bullfrog
    replied
    Re: Flasher Relay Issue

    It Will Get Progresively Worse, However Untill It Drives You Banana's, Ignore It. TURN THE RADIO UP!
    Last edited by Bullfrog; 11-22-2007, 09:58 AM.

    Leave a comment:


  • JustALilBit
    replied
    Re: Flasher Relay Issue

    I had this same problem. Im not big on doing this but it worked this time.
    I had it booked in to get replaced/checked. In the two week period from booking it stopped. This was about 4 months ago and it hasnt happened since.
    Maybe if your lucky the problem will correct itself

    Leave a comment:


  • Bullfrog
    replied
    Re: Flasher Relay Issue

    Most Likely The Turn Signal Arm, Rarely The Hazard Switch Only

    Leave a comment:


  • 100%VAGitarian
    replied
    Re: Flasher Relay Issue

    it is the whole turn stalk.

    Leave a comment:


  • bocefus
    replied
    Re: Flasher Relay Issue

    I had this happen to me this past summer, just wait until it starts clicking non-stop all the time...

    I first replaced the hazard switch, it was cheap so might as well start there. Unfortunately it turned out to be the signal stalk and I had that replaced.

    I still have the hazard switch I bought, since the original was ok I didn't bother swapping it out, you can have it to test out if you want (it takes 30 seconds to swap out). I'm working out of town this week but I'll drop it at my office in the SE this morning just in case, pm you with the details.


    Shane

    Leave a comment:

Working...
X