Re: Flasher Relay Issue
i sprayed a whack of electrical cleaner in there, and it hasn't clicked since. been a little over a week now. see what happens.
Announcement
Collapse
No announcement yet.
Flasher Relay Issue
Collapse
X
-
Re: Flasher Relay Issue
Originally posted by Kordain View PostStop!
be carefull with a propane heater in a confined space, they burn oxygen to make the flame and can quickly consume the air in a given space.
Thank you for reading todays gratis safety anouncement.
Carry on!
Leave a comment:
-
Re: Flasher Relay Issue
if you go to the trouble of pulling the switch to clean it, why not just replace it and save doing it twice?
Leave a comment:
-
Re: Flasher Relay Issue
Stop!
be carefull with a propane heater in a confined space, they burn oxygen to make the flame and can quickly consume the air in a given space.
Thank you for reading todays gratis safety anouncement.
Carry on!
Leave a comment:
-
Re: Flasher Relay Issue
OK, stop!!!!
The problem is that little metal bits contaminate the grease in the turn signal switch.
Get a can of contact cleaner. Stick the nozzle in behind the turn signal stalk. Spray, wiggle, spray........ That usually fixes the problem.
If that is not succesful, you can remove, clean, regrease and reinstall the switch. You should not need to replace it.
Leave a comment:
-
Re: Flasher Relay Issue
Garage is not heated but I just bought a propane heater... then emptied my tank lol I am going to fill it tomorrow and you know you are welcome to use it whenever you wantI can even give you a hand as I have taken the airbag off and changed stalks etc on Ryans old car.
Leave a comment:
-
Re: Flasher Relay Issue
disconnect battery. remove airbag. remove steering wheel, remove column covers. unplug switches. split the 2 switches apart. install new, repeat in reverse order.
Leave a comment:
-
Re: Flasher Relay Issue
Originally posted by bocefus View PostI had this happen to me this past summer, just wait until it starts clicking non-stop all the time...
I first replaced the hazard switch, it was cheap so might as well start there. Unfortunately it turned out to be the signal stalk and I had that replaced.
I still have the hazard switch I bought, since the original was ok I didn't bother swapping it out, you can have it to test out if you want (it takes 30 seconds to swap out). I'm working out of town this week but I'll drop it at my office in the SE this morning just in case, pm you with the details.
Shane
Big deal to swap this out? i can't imagine there is anything to difficult, other than being in an awkward spot.
**found a few great DIY's, think its all within my capability... but if you've done it, feel free to chime in with advise.
Brent... your garage isn't heated is it?Last edited by stefan; 11-22-2007, 10:50 AM.
Leave a comment:
-
Re: Flasher Relay Issue
I had this same problem. Im not big on doing this but it worked this time.
I had it booked in to get replaced/checked. In the two week period from booking it stopped. This was about 4 months ago and it hasnt happened since.
Maybe if your lucky the problem will correct itself
Leave a comment:
-
Re: Flasher Relay Issue
Most Likely The Turn Signal Arm, Rarely The Hazard Switch Only
Leave a comment:
-
Re: Flasher Relay Issue
I had this happen to me this past summer, just wait until it starts clicking non-stop all the time...
I first replaced the hazard switch, it was cheap so might as well start there. Unfortunately it turned out to be the signal stalk and I had that replaced.
I still have the hazard switch I bought, since the original was ok I didn't bother swapping it out, you can have it to test out if you want (it takes 30 seconds to swap out). I'm working out of town this week but I'll drop it at my office in the SE this morning just in case, pm you with the details.
Shane
Leave a comment:
Leave a comment: