New dyno #'s on built bottom end

[Disturbo]

So I went to a dyno a few days ago (mustang dynamometer) thats why the #'s seem low 304.9 whp and 278 tq. The dyno was done at 20.6psi on 91 oct. I had to much fuel so the ms 109 didnt really work so well . I installed a turbo smart dual stage mbc on the car and it didnt wanna boost over 20 psi no matter what we did with it

[Canadian Turbo]

Re: New dyno #'s on built bottom end

Still very impressive!!!!!!!!!

[R_Ethug]

Re: New dyno #'s on built bottom end

your still getting really good power mid range so everyday is still good dom

[Kor]

Re: New dyno #'s on built bottom end

On a built bottom I guess you want to be boosting 25, so that explains the numbers? Did you lower compression at all?

What turbo do you use again? I find it hard to believe you maxed it out, you sure you have no leaks?

[Disturbo]

Re: New dyno #'s on built bottom end

No leaks and the turbo didnt max out yet the mbc didnt wanna let me turn up the boost. The turbo is a t3t4 60 trim and the compression is stock still. On a dyno jet it would make 346whp cause the mustang show 13.6% lower

[asp gti]

Re: New dyno #'s on built bottom end

are your engine internals stock? like stock rods, pistons, cams ?

[Mitcheh]

Re: New dyno #'s on built bottom end

"built bottom end"

[asp gti]

Re: New dyno #'s on built bottom end

"built bottom end"

thanks, didnt see that, so what have u got in there then?

[Klobi-One-Kinobi]

Re: New dyno #'s on built bottom end

thanks, didnt see that, so what have u got in there then?

I think just rods, which are a good idea when going big turbo on the 1.8t. Pretty good #'s on that dyno, around 400 crank hp on 91 gas. Shame about the boost issue, time for a nice ebc and 25+psi, Dom.

[Disturbo]

Re: New dyno #'s on built bottom end

I have new rods, bolts,rings and turbo. I have cams that I will install later on. I will go to C1 and make a 400whp plus pull when I get the boost up to where I want it

[asp gti]

Re: New dyno #'s on built bottom end

where did u get rods and everything from, also where did u get them installed or did u do it yourself?

[greenGS]

Re: New dyno #'s on built bottom end

Which place did you go to? Toma's or Tecmotion. I've been on both and you should stick with either. don't bother going on a dynojet at this point. Mustang dynos are better for tuning anyways. Those are very impressive numbers don't worry about them being low after all dyno is a tuning tool